Catalogue

Catalogue →  Equipment for repair armature and phase rotors

	02.01.20 Balancing machine
	Balancing machine is intended for rotor balancing.

	03.05.40 Tinning bath
	The bath is intended for tinning of copper wire, tyre and tips of cables of electrotechnical products. It is applied in the time of repair and manufacturing of windings of electric equipment.

	04.01.05 Drawing device
	Drawing device is intended to draw the wire while fixing bandage to the armature or phase rotor.

	04.01.06 Drawing device
	Drawing device is intended to draw the glass tape while fixing bandage to the armature or phase rotor.

	04.01.07; 04.01.07.03 Machine to repair phase rotors and armature
	Machine to repair phase rotors and armature is intended for cleaning commutators, glass tape bandaging and pulling the rods out of the rotor grooves.

	04.01.17 Device to deflect shackles
	The device is intended for deflecting copper shackles. It is applied to assemblage of schemes using rod windings in the time of repair of electric motors.

	04.01.07.01; 04.01.07.02 Collectors slotting machine
	Collectors slotting machine is intended for slotting armature collectors by automated operation.

	04.01.09 Machine to remove a set of contact
	Machine to remove a set of contact is intended to remove a set of contact rings from electric motor rotors with the centre height up to 315 mm.

	04.01.10 Rack for rotors
	Rack for rotors is intended for setting and turning armatures and rotors or electric machines.

	04.02.40 Tinning crucible
	Tinning crucible is intended for tinning of copper wire and tips of cables of electrotechnical products. It is applied in the time of repair and manufacturing of windings of electric equipment.

	04.02.48 Machine to rewind pole coils on the rib.
	Machine to rewind pole coils on the rib is intended for rib winding of DC motor pole coil bus-bars.

	04.02.09 Drying installation
	Drying installation is intended for convection drying of large size parts with mechanized loading and automatic control of the drying mode. Control units provides up to 60 drying programs.

	04.03.26 Impregnating tank
	Impregnating tank is intended for impregnating electrical equipment in electroisolating varnishes.

	04.03.34 Manual lever scissors
	Manual lever scissors are intended for cutting sheet isolation materials used while repairing electric motors.

	04.02.29 Multipurpose machine toll
	Multipurpose machine toll is intended for removing bearings from electric motor rotors and pulling annular windings out of electric motor stators with the height of the centers up to 315 mm.

	04.01.03 Multipurpose machine
	Multipurpose machine is intended for pulling roads out of phase rotors, annular windings out of electric machine stators and rotor plus stator assembly.