Catalogue

Catalogue →  Equipment for restore winding wires

	03.04.05 Installation to clean and restore the wire
	Installation to clean and restore the wire is intended for restoration and cleaning of winding wires from old isolation left after annealing.

	03.04.06 Installation to isolate wires
	The installation is intended for putting glasstape isolation on copper wires of annular section with diameter from 1,6 to 4,1 mm and rectangular section with dimensions from 1x3mm to 3x90 mm, with simultaneous laying, impregnation and drying.

	04.03.12 Installation to isolate wires
	The installation is intended to isolate winding wires by means of tape isolating materials.

	03.04.07 Annealing furnace
	Annealing furnace is intended for copper wire annealing for recurring application. Annealing is performed without oxygen access. Annealing chamber is isolated from environment by water gate.

	03.04.09 Machine to cut isolation paper
	Machine to cut isolation paper is intended for cutting coils made of electrotechnical paper of 500-750 mm width into rolls of 20-150 mm width.